Burnham's Independence PV boilers offer you the flexibility of a power vent system. This boiler can be installed virtually anywhere because no chimney is required for operation. A draftinducing fan pulls hot gases through the heat exchanger at the correct speed for optimum efficiency. Operating together, the fan and heat exchanger provide more heat with less fuel consumption
The cast iron sections on the heat exchanger are linked by metal couplings called push nipples. These push nipples increase the longevity of a Burnham boiler by resisting the petroleum based antifreeze commonly used in hydronic heating systems. Many competitive products use a rubbertype gasket for this purpose. This type of gasket will begin to deteriorate when it comes in contact with hydronic antifreeze.
Independence boilers are made with cast iron sections that are produced at Burnham's own foundry and are assembled and tested at Burnham's facilities in Lancaster, PA. This ensures the quality and availability of this vital component. Burnham is the only boiler manufacturer that can make this claim.
Note: The approved venting system for the Independence PV is 3" AL294C stainless steel. Do not substitute other materials.
- Steam boiler
- Natural gas
- Power Vented
- Cast iron sectional design
- Stainless steel burners ensure years of reliable, rustfree operation
- Stepopening gas valve enables boiler to start on low fire and progress to high fire. This provides safe & smooth operation, quiet ignition, and longer component life.
- Industrial quality pressuretrol for accurate, troublefree control
||Category III Stainless Steel
Burnham IN3PVNIM2 is also known as in3pvnim2